Refitting

(Cont. Op. 3340A80)

• Remove the ABS wiring harness from the clips on the floor.

1. Remove the rear right-hand wheel revolution sensor from the floor.

1. Remove the rear left-hand wheel revolution sensor from the floor.

• Remove the ABS wiring harness from the engine compartment.

Refitting

• Refit the ABS wiring harness in the engine compartment.
• Fit the ABS wiring harness in the clips on the floor.
• Fit the rear right-hand wheel revolution sensor wire in its seat on the floor.
• Fit the rear left-hand wheel revolution sensor wire in its seat on the floor.
• Reposition the mat on the floor and fasten it with the rear screws.
• Complete with Op. 7050A20 Single rear seat cushion - R.R.
• Fasten the lower front right-hand seat belt fastening screw and fit the cap on the screw.
• Connect the ABS wiring harness connector to the dashboard wiring harness.
• Connect the earth and fasten the specific screw.

• Fit the footboard on the doors and fasten it with the screws.
• Reposition the power steering ECU bracket and fasten the fastening nuts.
• Fit the ABS wiring harness in the clips in the engine compartment.
• Reposition the lower soundproofing bracket.
• Assemble the soundproofing guard and fasten with the screws.
• Fit the engine compartment gasket on the soundproofing panel.
• Fit the fuel pipes and fasten the screw.
• Fit the ABS ECU bracket in the engine compartment and fasten the rear fastening screw.
• Fasten the screw fastening the ABS ECU bracket to the front left-hand wheelhouse.
• Fasten the brake fluid reservoir fastening nuts.
• Raise the vehicle.
• Connect the rear wheel revolution sensor electrical connections.

• Fasten the ABS ECU fastening nut
• Lower the vehicle.
• Connect the ABS ECU earth electrical connection and fasten the fastening screw.

• Connect the front left-hand wheel revolution electrical connection.

• Fit the diagnostic socket in the support.

(Cont.d)