Workshop Manuals Factory service & repair Fiat
Fiat Seicento Factory Service Manual (1998-2010)06 · 33 Braking system
06 · General

Refitting

Make
Fiat
Model
Seicento Factory Service Manual
Year
1998–2010
Section
Anti-lock braking system (ABS) › Refitting
33 Braking systemRefitting

(Op. 3340A30 continued)

  • Follow Op. 4450B10 Front WHEEL (one)- R.R.
  1. Loosen the screw (1a) and remove the wheel revolution sensor (1b) or (1c) with its electrical wiring.
NameConnector
1b LH ABS front wheel sensorK70
1c RH ABS front wheel sensorK71
Diagram of front wheel hub area showing the location of the ABS front wheel sensors labeled 1a, 1b, and 1c

Refitting

  • Fit the revolution sensor and electrical wiring on the front wheel hub and fasten it with the respective screw.
NameConnector
LH ABS front wheel sensorK70
RH ABS front wheel sensorK71
  • Complete with Op. 4450B10 Front WHEEL (one) - R.R.
  • Connect the front wheel revolution sensor electrical connection.
  • Connect the battery (-) terminal.
NameConnector
BatteryA1
  • Remove the body protection cover.
  • Close the engine compartment.
  • Remove the vehicle from the shop jack.

3340A34 - REAR WHEEL REVOLUTION SENSOR (ONE), LH OR RH, R.R.

Removal

  • Position the vehicle on a shop jack.
  • Open the engine compartment.
  • Disconnect the (-) battery terminal.
NameConnector
BatteryA1
  • Follow Op. 4450B11 Rear WHEEL (one) - R.R.
  1. Disconnect the rear wheel revolution sensor electrical connection.
Diagram of rear suspension area showing the rear wheel revolution sensor and its electrical connector
  1. Loosen the screw (1a) and remove the wheel revolution sensor (1b) or (1c) with its electrical wiring.

(Continued)

Parts & tools for this job For 1998 Fiat Seicento

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.