Refitting

(Cont. Op. 5010A16)

1. Take out the lower sleeve from the radiator, drain off part of the engine coolant into a suitable container and reconnect the sleeve.

• Assemble the engine compartment protection and fasten with its screws.
• Lower the vehicle.

1. Take off the fuses/relay group from the support and move it without disconnecting the electrical connections.
2. Partially remove the engine compartment gasket.
3. Unscrew screws (3a) of the soundproofing guard (3b) and remove it.

1. Take out the water return pipe from the heater.

1. Take out the pipe from the throttle case.
2. Take out the intake manifold pipe and remove it.

Refitting

Note: Before refitting the pipe check it is not damaged or has cracks that could influence the seal.

• Reposition the water return pipe and insert it in the heater.
• Insert the pipe in the throttle case.
• Insert the pipe on the intake manifold.
• Assemble the soundproofing guard and fasten with the screws.
• Fit the engine compartment gasket.
• Reposition the fuses/relay group and fit it on the support.

(Cont.d.)