Workshop Manuals Factory service & repair Fiat
Fiat Seicento Factory Service Manual (1998-2010)10 · 55 Electrical equipment
10 · Electrical

Reassembly

Make
Fiat
Model
Seicento Factory Service Manual
Year
1998–2010
Section
Accessories › Reassembly
55 Electrical equipmentReassembly

(Op. 5570T31 continued)

  1. Disconnect the electric connection and take the volumetric sensor support.
DescriptionConnector
1Alarm remote control receiverM35
Diagram showing the alarm remote control receiver unit with an electrical connector being disconnected
  1. Lift the sunroof seal (1a) as required.
  2. Lift the door frame seal (2a) as required.
  3. Lower the front right-hand roof panel slightly.
Diagram showing the radio aerial connection point on the roof and the location of the retainer screws
  1. Disconnect the radio aerial connection.
  2. Release the radio aerial cable from the retainers on the roof and right-hand front riser.
Diagram showing the routing of the radio aerial wire along the dashboard crossmember and its connection point
  1. From under the dashboard panel, disconnect the aerial wire from the retainers on the crossmember.
  2. Extract the aerial wire.
Diagram showing the repositioning of the radio aerial wire and roof panel within the vehicle interior

Reassembly

  • Check that the radio aerial is not damaged.
  • If required, check electric continuity of conductor and shielding.
  • Reposition the radio aerial wire in its seat.
  • Fasten the wire to the retainers.
  • Connect the aerial wire connection.
  • Reposition the roof panel in its seat.
  • Fit the sunroof seal in its seat.
  • Fit the door frame seal in its seat.
  • Connect volumetric sensor support electric connection.
  • Reposition the volumetric sensor support and fasten it with its screws.

(Cont..)

Parts & tools for this job For 1998 Fiat Seicento

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.