Workshop Manuals Factory service & repair Fiat
01 00 General information and technical data02 10 Engine03 18 Clutch04 21 Gearbox and differential05 27 Axle06 33 Braking system07 41 Steering08 44 Suspension and wheels09 50 Auxiliary units10 55 Electrical equipment11 70 Bodywork12 Diagnosis13 Tests14 Wiring diagrams
Fiat Seicento Factory Service Manual (1998-2010)12 · Diagnosis
12 · Diagnostics

P10 Door locking device not working

Make
Fiat
Model
Seicento Factory Service Manual
Year
1998–2010
Section
Doors › P10 Door locking device not working
DiagnosisP10 Door locking device not working

P10 Door locking device not working

Operating the door locking device with the key (or with the remote control) the doors do not lock/un- lock at all.

If the door locking device works with the key but not with the remote control, see table P11

Preliminarily check:
– the repeat protection device has not been engaged
– battery voltage not less than 9 V
In these conditions, in fact, the door locking device is not powered by the ECU

Step Validity Operation to be performed Test results
All OK Problems found Intervention
1 CHECK DOOR LOCKING DEVICE ELECTRIC CIRCUIT
Check in sequence:
– door locking device fuse (F1)
– connection between junction unit and door locking device ECU
– connection between door locking device ECU and door lock (geared motor)
– door locking device ECU earth
– door lock switch earth (Wiring diagram: E3040 “Door locking device”)
Go to Step 2 Incorrect connections Restore connections
Faulty component Replace component (if it is a fuse, investigate the causes which may have triggered it)
All OK – –
2 CHECK DOOR LOCKING DEVICE ECU AND GEARED MOTORS
Lock/unlock the doors and check:
– 12V between door locking device ECU connector pins 2 and 3
– polarity is inverted at each operation
(Wiring diagram: E3040 “Door locking device”)
Go to Step 3 No voltage Check and if required replace the door lock geared motors
PROCEDURE OP. 7005N27
Regular voltage Replace the door locking device ECU
PROCEDURE OP. 7005N40
All OK – –
3 CHECK CORRECT OPERATION
Check the fault is no longer present
End of test – –

Parts & tools for this job For 1998 Fiat Seicento

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.