Workshop Manuals Factory service & repair Fiat
01 00 General information and technical data02 10 Engine03 18 Clutch04 21 Gearbox and differential05 27 Axle06 33 Braking system07 41 Steering08 44 Suspension and wheels09 50 Auxiliary units10 55 Electrical equipment11 70 Bodywork12 Diagnosis13 Tests14 Wiring diagrams
Fiat Seicento Factory Service Manual (1998-2010)12 · Diagnosis
12 · Diagnostics

K80 Airbag fault warning light on

Make
Fiat
Model
Seicento Factory Service Manual
Year
1998–2010
Section
On-board instruments › K80 Airbag fault warning light on
DiagnosisK80 Airbag fault warning light on

K80 Airbag fault warning light on

Airbag fault warning light on

When the engine is started, the “airbag fault” warning light comes on and stays on for longer than 4 seconds (after running the ECU initial test, the warning light should come off)

In the event of a particularly severe crash which caused complete activation of the system (airbag and pretensioners) the light stays on. As erasure from the ECU is not possible, replace the latter.

If only the pretensioners were activated, the memory may be erased using the diagnostic tools (Examiner of other tools) twice. In this case, the “airbag fault” warning light goes out. The ECU must be replaced only when activated for the third time.

Step Validity Operation to be performed Test results
OK ⚠ 🔧
Problems found Intervention
1 CHECK WITH DIAGNOSTIC TOOL Connect diagnostic tool (Examiner or other tools) to the diagnostic socket.
Check
– no errors in the airbag ECU
– plausibility of all parameters
All OK Failed dialogue with the ECU Continue as shown by the diagnostic tool
Go to Step 2 Error detected in ECU Restore:
– connection between airbag ECU and diagnostic socket
(Wiring diagram: E7030 “Airbag”)
2 CHECK ELECTRIC CIRCUIT NOTE The “airbag” warning light is fitted with a special internal drive unit that checks correct connection between the warning light itself and the ECU. Therefore, check connection between airbag ECU and instrument panel.
(Wiring diagram: E7030 “Airbag”)
All OK Incorrect connections Restore connections
Go to Step 3
3 CHECK CORRECT OPERATION Check the fault is no longer present All OK Fault persists Seek the fault starting from another symptom. Check and, if required, replace airbag ECU
PROCEDURE OP. 5580C14
End of test

Parts & tools for this job For 1998 Fiat Seicento

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.