Single engine belt r r

Operation 1092G10 · Single drive belt for various engine components

1.2 16v

Removing

1. Using the belt tensioner (1a), slacken the tension of the single drive belt (1b).

Remove the belt from the pullies.

1.4 16v

Removing

1. Using the belt tensioner (1a), slacken the tension of the single drive belt (1b).

Remove the belt from the pulleys.

1.9 JTD 8v

Removing

Place the car on a ramp.

- 7055B54 under-engine guard - r r

- 4450B04 right front wheel r r

- 7055B42 Additional FRONT WHEEL ARCH (one), left or right - R.R.

1. Act on the moving tensioner to loosen the tension of the engine components single drive belt.

2. Remove the auxiliary shaft drive belt.

1.9 JTD 16v

Removing

Position the vehicle on the ramp

- 4450B04 right front wheel r r.

- 7055B54 under-engine guard - r r.

- 7055B42 Additional FRONT WHEEL ARCH (one), left or right - R.R..

1. Adjust the moving tensioner (1a) with a wrench and remove the and single auxiliary drivebelt (1b).

1.2 16v

Refitting

Fit the belt on the engine and alternator pullies.

Using the belt tensioner, fit the belt on the air conditioner compressor pulley.

Release the tensioner.

1.4 16v

Refitting

Fit the belt on the engine and alternator pullies.

Using the belt tensioner, fit the belt on the air conditioner compressor pulley.

Release the tensioner.

1.9 JTD 8v

Refitting

Fit a new single drive belt on the pullies.

Do not allow oil or solvents to come into contact with the belt, as these could affect the flexibility of the rubber, resulting in reduced grip. Also check that there are no cracks or cuts on the belt, otherwise it will have to be replaced.

The tensioning device is automatic: a preloaded spring adjusts the belt to the correct tension upon installation and automatically takes up any slack in the belt generated during normal operation.

Act on the automatic tensioning device and place it in the maximum pre-loading position, fit the auxiliary shaft drive belt and slowly release the tensioning device.

- 4450B04 right front wheel r r

- 7055B42 Additional FRONT WHEEL ARCH (one), left or right - R.R.

- 7055B54 under-engine guard - r r

Remove the vehicle from the ramp.

1.9 JTD 16v

Refitting

Adjust the moving tensioner and fit the engine components single drive belt using a spanner.

- 7055B42 Additional FRONT WHEEL ARCH (one), left or right - R.R..

- 7055B54 under-engine guard - r r.

- 4450B04 right front wheel r r.

Remove the car from the ramps.