22 · Diagnostics

Abs and handbrake warning lights both on

Make: Lancia
Model: Ypsilon Factory Service Manual
Year: 2003–2011
Section: Instrument panel › Abs and handbrake warning lights both on

‹ Prev Abs warning light off / (do not carry out initial test)Next › Airbag failure warning light on

Fault diagnosisAbs and handbrake warning lights both on

ABS AND HANDBRAKE WARNING LIGHTS BOTH ON

The handbrake lever is released

The handbrake warning light also indicates that the brake fluid level is low and, if it is on at the same time as the ABS warning light, the malfunction of the EBD system.

A parking brake warning light activation command is sent by the switch on the lever to the Body Computer Node, which makes it available to the Instrument Panel Node via the B-CAN network

1	PRELIMINARY CHECK	All OK	Problems met	Operation
		Results of the tests
	Connect the EXAMINER diagnostic equipment and check the CAN NETWORK INFORMATION: For inactive control units For control units with errors For control units with CAN errors	Continue to Step 2	Presence of fault in the CAN	Continue as instructed by the tester
		Continue to Step 2	Impossible to converse with the Body Computer	Continue to Step 8
2	CHECK WITH DIAGNOSTIC EQUIPMENT	All OK	Problems met	Operation
	Keeping the diagnostic equipment connected, check that there are no CAN problems at the BRAKE NODE	Continue to Step 2	Faults present at the C-CAN	Continue to Step 10
3	CHECK WITH DIAGNOSTIC EQUIPMENT	All OK	Problems met	Operation
	Using the Examiner check, in the Instrument Panel Node ambient, that there are no errors and the following parameters are present.	Continue to Step 4	There are errors	Continue in accordance with the instructions for the diagnostic equipment
4	ELECTRIC POWER SUPPLY CHECK	All OK	Problems met	Operation
	Check that the Instrument Panel Node electrical power supply is correct.	Continue to Step 5	Positive and/or earth electrical power supply fault.	Replace the defective component (if a fuse is involved, search for the cause of the problem).
5	CHECK ELECTRICAL CONNECTIONS	All OK	Problems met	Operation
	Check the electrical connections between the Body Computer and the Instrument Panel, in particular that each individual pin is correctly connected.	Continue to Step 6	Electrical connections not working.	Restore damaged electrical connection.
6	CHECK WITH ACTIVE DIAGNOSIS	All OK	Problems met	Operation
	With the Examiner in the Instrument Panel Node ambient, check, in active diagnosis, that the failure warning lights are correctly activated	Continue to Step 7	The warning lights do not flash	Replace the instrument panel Op. 5560B11
7	CHECK WITH DIAGNOSTIC EQUIPMENT	All OK	Problems met	Operation
	Using the Examiner check, in the Body Computer Node ambient, that there are no errors	Continue to Step 10	There are errors	Continue to Step 8
		Continue to Step 10	There are errors	Continue in accordance with the instructions for the diagnostic equipment.
8	ELECTRIC POWER SUPPLY CHECK	All OK	Problems met	Operation
	Check that the Body Computer Node electrical power supply is correct.	Continue to Step 9	Positive and/or earth electrical power supply fault.	Replace the defective component (if a fuse is involved, search for the cause of the problem).
9	CHECK WITH DIAGNOSTIC EQUIPMENT	All OK	Problems met	Operation
	Using the Examiner, check the possibility of connecting with the Body Computer Node.	Continue to Step 7	Impossible to connect with the Body Computer control unit.	Replace the Body Computer Op. 5505A32
10	CHECK ON CORRECT OPERATION	All OK	Problems met	Operation
	Check that the fault is no longer present	End of diagnosis	The fault persists	Replace the Body Computer Op. 5505A32

‹ Prev Abs warning light off / (do not carry out initial test)Next › Airbag failure warning light on

Parts & tools for this job For 2003 Lancia Ypsilon

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.