300Tdi Defender
30
MANIFOLD AND EXHAUST SYSTEM
4
REPAIR
INTERMEDIATE PIPE - 90
Service repair no - 30.10.11
Remove
1. Raise vehicle on ramp.
2. Release intermediate pipe from front mounting
rubber, see J6243.
3. Remove 2 flange nuts securing intermediate
pipe to tail pipe.
4. Release intermediate pipe from rear mounting
rubber.
5. Remove 2 flange nuts securing intermediate
pipe to front pipe.
6. Release intermediate pipe from front and tail
pipe and remove.
Refit
7. Fit intermediate pipe to front and tail pipes.
8. Secure intermediate pipe to front and rear
mounting rubbers.
9. Secure intermediate pipe to front pipe. Tighten
nuts to
30 Nm (22 lbf/ft).
10. Secure intermediate pipe to tail pipe. Tighten
nuts to
30 Nm (22 lbf/ft).
11. Lower vehicle.
INTERMEDIATE PIPE - 110/130
Service repair no - 30.10.11
Remove
1. Raise vehicle on ramp.
2. Release intermediate pipe from mounting
rubber, see J6244.
3. Remove 2 flange nuts securing intermediate
pipe to tail pipe.
4. Remove 2 flange nuts securing intermediate
pipe to front pipe.
5. Release intermediate pipe from front and tail
pipe and remove.
Refit
6. Fit intermediate pipe to front and tail pipes.
7. Secure intermediate pipe to mounting rubbers.
8. Secure intermediate pipe to front pipe. Tighten
nuts to
30 Nm (22 lbf/ft).
9. Secure intermediate pipe to tail pipe. Tighten
nuts to
30 Nm (22 lbf/ft).
10. Lower vehicle.