TD5 Defender Glow Plug Warning Lamp - Engine Management System
ENGINE MANAGEMENT SYSTEM
23
DESCRIPTION AND OPERATION
MODULATOR - EXHAUST GAS REGULATOR (EGR)
The EGR modulator is located on the RH side inner front wing. It regulates the vacuum source to the EGR valve
allowing it to open or close. The ECM utilises the EGR modulator to control the amount of exhaust gas being
recirculated in order to reduce exhaust emissions and combustion noise. Optimum EGR is usually obtained when
the vehicle is operating at light throttle openings, and the vehicle is cruising at approximately 2000 to 3000
rev/min.
Input / Output
The EGR modulator (C0191-1) receives a feed from the main relay (C0063-87) on a brown/orange wire via header
294. The earth path for the modulator (C0191-2) is controlled by the ECM (C0158-3) on a blue wire. The length of
time the ECM supplies an earth is how long the exhaust gases are allowed to recirculate. The ECM decides how
long to supply the earth by looking at engine temperature and engine load.
The EGR modulator can fail in one or more of the following ways:
•
Solenoid open circuit.
•
Short circuit to vehicle supply.
•
Short circuit to earth.
In the event of an EGR modulator failure, the EGR system will become inoperative.
WARNING LAMP - GLOW PLUG
The glow plug warning lamp is located in the instrument pack. It illuminates to alert the driver that the glow plugs
are being heated prior to the engine being started. The length of time that the lamp illuminates and the glow plugs
are operating prior to cranking is the pre-heat period. The length of time of this period is determined by the ECT
sensor signal, controlled by the ECM.