TD5 Defender
WIPERS AND WASHERS
7
REPAIR
NOTE: Do not carry out further
dismantling if component is removed for
access only.
10. Remove 2 bolts securing wiper motor to
mounting bracket, remove bracket.
Refit
11. Fit mounting bracket to motor and tighten bolts
to 10 Nm (7 lbf.ft).
12. Fit motor spindle to rear door, connect multiplugs
and push motor fully home. Align motor
mounting bracket with solenoid mounting
bracket, fit bolt and tighten to 10 Nm ( 7 lbf.ft ).
13. Fit rear door trim casing. See CHASSIS AND
BODY, Repair.
14. Fit washer and nut to rear wiper assembly,
tighten nut to 3 Nm (2.2 lbf.ft).
15. Fit wiper arm to spindle, align blade to glass and
tighten nut to 17 Nm (13 lbf.ft).
16. Close nut cover.
17. Fit spare wheel and tighten nuts to 45 Nm (33
lbf.ft).
RELAY - TAIL DOOR WIPER - FROM 02MY
Service repair no - 84.35.38
Remove
1. Remove tail door trim casing. See CHASSIS
AND BODY, Repair.
2. Remove rear wiper motor relay.
Refit
3. Fit relay.
4. Fit tail door trim casing. See CHASSIS AND
BODY, Repair.