Workshop Manuals Factory service & repair Land Rover
01 Introduction02 General information03 Information04 Maintenance05 Engine - K Series06 Engine - L Series07 Emission control08 Engine management system - MEMS09 Engine management system - EDC10 Fuel delivery system11 Cooling system - K Series12 Cooling system - L Series13 Manifold & exhaust systems14 Clutch15 Manual gearbox - PG116 Transfer box - IRD17 Drive shafts18 Rear axle and final drive19 Steering20 Front suspension21 Rear suspension22 Brakes23 Restraint systems24 Body25 Heating & ventilation26 Air conditioning27 Wipers & washers28 Electrical29 Instruments
Land Rover Freelander Workshop Manual (1998-2000)28 · Electrical
28 · Electrical

Anti theft alarm system (Electrical)

Make
Land Rover
Model
Freelander Workshop Manual
Year
1998–2000
Section
Description and operation › Anti theft alarm system
ElectricalAnti theft alarm system · page 1 of 2

ANTI THEFT ALARM SYSTEM

The anti theft alarm system controls the central locking and alarm functions for the vehicle. The vehicle locking and alarm system comprises the following components:

  • Remote handset (RF transmitter)
  • RF receiver
  • Passive coil
  • Volumetric sensor
  • Door lock actuators
  • Drivers door key barrel
  • Central door locking (CDL) switch
  • Door switches
  • Tail door switch
  • Bonnet switch
  • Horn or BBUS
  • Alarm LED
  • Starter relay
  • Inertia switch
  • Engine immobilisation

Central Locking

The vehicle can be locked and unlocked by three methods; CDL switch, vehicle key or remote handset.

CDL Switch

The CDL switch is located in the centre console. The CDL switch allows the occupants to CDL lock the vehicle from inside without arming the alarm. The CDL switch is inoperative if the inertia switch is tripped. The CDL locked state can be removed by operation of the CDL switch, remote handset or key unlock in the drivers door key barrel. If the inertia switch is tripped while the doors are CDL locked and the ignition is on, all doors will automatically unlock.

Key locking

The vehicle can be CDL locked using the vehicle key in the driver’s door key barrel. Turning the top of the key to the rear of the vehicle will CDL lock all doors. Turning the key a second time, within one second of the first turn, will superlock all doors.

Key Unlocking

On vehicles with alarm selected:

With the vehicle CDL or superlocked, turning the top of the key once to the front of the vehicle will mechanically unlock the driver’s door only. The vehicle will enter the Emergency Key Access (EKA) state. Refer to Emergency Key Access (EKA) in this section.

On vehicles with alarm not selected (market option):

With the vehicle CDL locked, turning the top of the key once to the front of the vehicle will unlock all the doors.

If the vehicle is superlocked, turning the top of the key once to the front of the vehicle will only unlock the driver’s door for Single Point Entry (SPE). The remaining door(s) will unlock to the CDL state. If the key is turned a second time, the remaining door(s) will unlock.

NOTE: If the vehicle is superlocked and SPE has not been selected in the CCU, turning the top of the key once to the front of the vehicle will unlock all the doors.

Parts & tools for this job For 1998 Land Rover Freelander

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.