Console Switch Lower - One Shot (Electrical)

Console Switch Lower - One Shot

With the ignition on, pressing the console switch in the down position for a period of approximately 0.2 seconds or less, will signal the CCU to lower the tail door window fully. This feature is market programmable.

Roof Removal - 3 Door Models Only

If the alarm is not armed, removal of the roof will trip the roof off switch. This signals the CCU which automatically lowers the tail door window even if the tail door is open. If the roof is removed and the alarm is armed, operation of the roof off switch will trigger the alarm and the CCU will not lower the tail door window.

Tail Door Window Raise

NOTE: If the rear screen wiper was selected on when the tail door window was lowered, when the window is raised fully, the CCU will resume operation of the wiper providing the switch is still selected on.

Tail Door Key Barrel Raise

With the tail door closed and, on 3 door models the roof is on, inserting the key in the tail door key barrel and holding in the turned condition will signal the CCU to raise the tail door window. If the key is released before the window has reached the fully up position, the signal will be removed from the CCU and the window will fully lower.

Console Switch Raise

With the ignition on and, on 3 door models the roof is on, and the tail door closed, pressing the console switch in the up position will signal the CCU to raise the tail door window. The switch must be pressed until the window is fully raised (stalled position). If the switch is released and the window has not reached its stalled position, the raise signal is removed from the CCU and the window will be fully lowered.

Motor Timeout

To protect the tail door window lift motor from damage, the motor outputs have a fail-safe inhibit relative to the window height. This prevents the motor from being overdriven. If the fail-safe limit is reached, the CCU will energise the tail window down relay to lower the window and the CCU sets the window to an uncalibrated setting. The calibration procedure will need to be performed to recalibrate the tail door window.

Tail Door Window Open Warning.

If the tail door window is calibrated and open and, on 3 door models the roof is on, and a lock request is made from the remote handset or the vehicle key in the driver’s door key barrel, the CCU will sound an audible miss-lock warning to advise that the window is open. The window can be closed using the console switch or the tail door key barrel.