Bearing - hub - front (page 4 of 4)

Refit

1. Fit hub assembly to lower ball joint, fit nut and tighten to 65 Nm.
2. Fit drive shaft to hub.
3. Fit hub to suspension damper and tighten nuts and bolts to 205 Nm.
4. Clean disc and drive flange mating faces.
5. Fit disc to drive flange, align reference marks, fit screws and tighten to 5 Nm.
6. Fit caliper, fit bolts and tighten to 83 Nm.
7. Align brake hose to bracket and fit clip.
8. Clean ABS sensor, apply anti-seize grease and fit sensor to hub.
9. Fit sensor lead to bracket.
10. Fit NEW drive shaft nut and tighten to 400 Nm. Stake nut to shaft.
11. Fit road wheel(s) and tighten nuts to correct torque. See INFORMATION, Torque wrench settings.
12. Remove stand(s) and lower vehicle.