Workshop Manuals Factory service & repair Land Rover
01 Introduction02 General information03 Information04 Maintenance05 Engine - K Series06 Engine - L Series07 Emission control08 Engine management system - MEMS09 Engine management system - EDC10 Fuel delivery system11 Cooling system - K Series12 Cooling system - L Series13 Manifold & exhaust systems14 Clutch15 Manual gearbox - PG116 Transfer box - IRD17 Drive shafts18 Rear axle and final drive19 Steering20 Front suspension21 Rear suspension22 Brakes23 Restraint systems24 Body25 Heating & ventilation26 Air conditioning27 Wipers & washers28 Electrical29 Instruments
Land Rover Freelander Workshop Manual (1998-2000)13 · Manifold & exhaust systems
13 · Engine

Exhaust pipe - tail

Make
Land Rover
Model
Freelander Workshop Manual
Year
1998–2000
Section
Repairs › Exhaust pipe - tail
Manifold & exhaust systemsExhaust pipe - tail

EXHAUST PIPE - TAIL

Service repair no - 30.10.22

Remove

  1. Raise rear of vehicle.

WARNING: Support on safety stands.

Exhaust pipe - tail – Raise rear of vehicle.
  1. Loosen tail pipe clamp nut.
  2. Release 2 rubber mountings from tail pipe.
  3. Remove tail pipe.

Refit

  1. Clean intermediate pipe and tail pipe mating faces.
  2. Fit tail pipe and connect rubber mountings.
  3. Tighten tail pipe clamp nut to 55 Nm.
  4. Remove stand(s) and lower vehicle.

Parts & tools for this job For 1998 Land Rover Freelander

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.