LR3/Disco 3
21 .
Remove the intake air shutoff throttle elbow support bracket.
Remove the three retaining bolts.
22 .
Remove the generator. For additional information, refer to
Generator (86.10.02)
(Section 414-02)
23 .
Disconnect the engine earth strap.
Remove the retaining bolt.
24 .
CAUTION: If power steering fluid comes into contact with the paintwork, the affected area
must be immediately washed down with cold water.
CAUTION: Make sure the timing blade on the high-pressure pipe union is not damaged.
Disconnect the power steering high-pressure pipe union.
Remove and discard the two sealing washers.
Install blanking caps to the exposed ports.
Allow the fluid to drain into a container.