LR3/Disco 3
Coolant Pump (26.50.01)
Removal
Installation
Published : Jun 30, 2004
1 .
Disconnect the battery ground cable. For additional information, refer to
Specifications
(Section 414-
00)
2 .
Drain the cooling system. For additional information, refer to
Cooling System Draining, Filling and
Bleeding (26.10.01)
(Section 303-03)
3 .
Remove the accessory drive belt. For additional information, refer to
Accessory Drive Belt (86.10.03)
(Section 303-05)
4 .
NOTE :
Loosen the bolts prior to removing the accessory drive belt.
Remove the coolant pump pulley.
Remove the 3 bolts.
5 .
Remove the coolant pump.
Remove the 3 bolts.
Discard the O-ring seal.
1 .
Install the coolant pump.
Clean the component mating faces.
Install a new O-ring seal.