LR3/Disco 3
Installation
All vehicles
15 .
With assistance, remove the BJB and wiring harness.
1 .
With assistance, install the BJB and wiring harness.
2 .
Connect the front bumper wiring harness electrical connector.
3 .
Attach the hood release cable.
Secure with the clips.
4 .
If installed, connect the pollution sensor electrical connector.
Install the grommet.
Secure the clip.
5 .
If installed, connect the speed control module electrical connector.
6 .
Connect the horn electrical connectors.
7 .
Connect the hood switch electrical connector.
8 .
RH side: Secure the wiring harness.
Secure the clips.
9 .
Connect both front impact electrical connectors.
Secure the clips.
10 .
RH side: Attach the air suspension pipe.
11 .
Connect the ambient air temperature sensor electrical connector.
12 .
RH side: Attach the engine compartment ground cables.
Tighten the nuts to 25 Nm (18 lb.ft).