LR3/Disco 3
Vehicles with auxiliary heating
All vehicles
13 .
RH side: Connect the ABS electrical connector.
14 .
RH side: Attach the body panel ground cables.
Tighten the nut to 25 Nm (18 lb.ft).
15 .
RH side: Connect the body panel electrical connectors.
1 .
RH side: Secure the heater pipes to the body panel.
Tighten the nut to 10 Nm (7 lb.ft).
1 .
Driver side: Attach the wiring harness to the bulkhead.
Install the grommet.
2 .
Driver side: Connect the lower A-pillar electrical connectors.
3 .
Install the air suspension control module. For additional information, refer to
Air Suspension Control
Module (60.50.04)
(Section 204-05)
4 .
Connect the ABS module electrical connector.
5 .
Connect the brake fluid reservoir electrical connector.
6 .
Attach the wiring harness to the plenum.
Secure the clips.
Tighten the nuts to 4 Nm (3 lb.ft).
7 .
Connect the battery to engine compartment wiring harness electrical connector.
8 .
Connect the A/C pressure transducer electrical connector.
9 .
Connect the brake booster vacuum pump electrical connector.
10 .
Attach the hood wiring harness.
Install the grommet.
Install the cover.
Secure with the clips.
Connect the electrical connectors.
Connect the washer jet hoses.