Range Rover P38
ZF AUTO
1
ADJUSTMENT
SELECTOR CABLE
Service repair no - 44.30.04
Adjust
1. Raise the vehicle.
WARNING: Support on safety stands.
2. Slacken selector cable trunnion locknut. Remove
split pin. Release trunnion from gearbox lever.
3. Select ’P’. Position lever on transmission fully
forward.
4. Adjust trunnion until a sliding fit in transmission
lever is achieved.
5. Connect trunnion to lever. Fit split pin. Tighten
locknut.
6. Remove safety stands. Lower vehicle.
GEARBOX - DRAIN AND REFILL - FROM 99MY
Service repair no - 44.24.02
Drain
1. Position vehicle on ramp.
2. Apply handbrake and position chocks under
front and rear wheels.
3. Position container under gearbox.
4. Remove gearbox drain plug and discard sealing
washer.
5. Refit drain plug using new sealing washer and
tighten to
15 Nm (11 lbf.ft).
6. Remove filler/level plug and discard sealing
washer.
Refill
7. Refill gearbox to bottom of filler/level plug hole
with correct grade of fluid.
8. Ensure gear lever in the ’P’ position, start engine
and move selector lever through all gear
positions and back to ’P’ position.
9. With the engine idling, continue filling gearbox
until a small thread of fluid runs from filler/level
orifice.
10. Refit filler/level plug using a new sealing washer
and tighten to
30 Nm (22 lbf.ft).
11. Lower vehicle.