Workshop Manuals Factory service & repair Mazda
01 General information02 Engine03 Engine performance04 Transmission05 Driveline and axles06 Suspension07 Brakes08 Steering09 Restraints10 Heating and air conditioning11 Electrical12 Accessories and equipment13 Body and cab accessories
Mazda MX-5 (NC) Factory Workshop Manual (2006-2008)02 · Engine
02 · Engine

Magnetic switch operation inspection

Make
Mazda
Model
MX-5 (NC) Factory Workshop Manual
Year
2006–2008
Section
Starting System › Magnetic switch operation inspection
EngineMagnetic switch operation inspection
ENGINE – Starting System – figure
Fig. 6: No-Load Test - Circuit Diagram
Courtesy of MAZDA MOTORS CORP.

MAGNETIC SWITCH OPERATION INSPECTION

Pull-out Test

NOTE: Depending on the battery charge condition, the starter motor pinion may rotate while in an extended state. This is due to current flowing to the starter motor through the pull-in coil to turn the starter motor, and does not indicate an abnormality.

  1. Verify that the starter motor pinion is extended while battery positive voltage is connected to terminal S and the starter body is grounded.
    • If the starter motor pinion is not extended, repair or replace the starter.

Parts & tools for this job For 2006 Mazda MX-5

As an Amazon Associate we earn from qualifying purchases.