Workshop Manuals Factory service & repair Mazda
01 General information02 Engine03 Engine performance04 Transmission05 Driveline and axles06 Suspension07 Brakes08 Steering09 Restraints10 Heating and air conditioning11 Electrical12 Accessories and equipment13 Body and cab accessories
Mazda MX-5 (NC) Factory Workshop Manual (2006-2008)02 · Engine
02 · Engine

Starter installation note

Make
Mazda
Model
MX-5 (NC) Factory Workshop Manual
Year
2006–2008
Section
Starting System › Starter installation note
EngineStarter installation note · page 1 of 3
  1. Remove the under cover. (MT) (See TRANSVERSE MEMBER REMOVAL/INSTALLATION .)
  2. Remove the clutch release cylinder with the pipes still connected. Position the clutch release cylinder so that it is out of the way. (MT) (See TRANSMISSION REMOVAL/INSTALLATION [M15M-D] .) (See TRANSMISSION REMOVAL/INSTALLATION [P66M-D] .)
  3. Remove in the order indicated in Fig. 2 .
  4. Install in the reverse order of removal.
ENGINE – Starting System – figure
Fig. 2: Identifying Removal Order Of Starter (With Torque Specifications)
Courtesy of MAZDA MOTORS CORP.

STARTER INSTALLATION NOTE

NOTE: If there is peeling on or damage to the insulator, attach a new insulator using the following procedure:

  1. Peel off the insulator from the starter completely using a scraper.

Parts & tools for this job For 2006 Mazda MX-5

As an Amazon Associate we earn from qualifying purchases.