Workshop Manuals Factory service & repair Mazda
01 General information02 Engine03 Engine performance04 Transmission05 Driveline and axles06 Suspension07 Brakes08 Steering09 Restraints10 Heating and air conditioning11 Electrical12 Accessories and equipment13 Body and cab accessories
Mazda MX-5 (NC) Factory Workshop Manual (2006-2008)02 · Engine
02 · Engine

Starter inspection [lf]

Make
Mazda
Model
MX-5 (NC) Factory Workshop Manual
Year
2006–2008
Section
Starting System › Starter inspection [lf]
EngineStarter inspection [lf]

STARTER INSPECTION [LF]

ON-VEHICLE INSPECTION

  1. Verify that the battery is fully charged.
  2. The starter is normal if it rotates smoothly and without any noise when the engine is cranked.
    • If the starter does not operate, inspect the following:
    • Remove the starter, and inspect the starter unit.
    • Inspect the related wiring harnesses, the ignition switch, and the transmission range switch (AT).

NO-LOAD TEST

  1. Verify that the battery is fully charged.
  2. Connect the starter, battery and a tester as shown in Fig. 6 .
  3. Operate the starter and verify that it rotates smoothly.
    • If the starter does not rotate smoothly, inspect the starter unit.
  4. Measure the voltage and current while the starter is operating.
    • If not within the specification, replace the starter.

Starter no load test voltage

11 V

Starter no load test current

90 A or less

Parts & tools for this job For 2006 Mazda MX-5

As an Amazon Associate we earn from qualifying purchases.