Workshop Manuals Factory service & repair Mazda
01 General information02 Engine03 Engine performance04 Transmission05 Driveline and axles06 Suspension07 Brakes08 Steering09 Restraints10 Heating and air conditioning11 Electrical12 Accessories and equipment13 Body and cab accessories
Mazda MX-5 (NC) Factory Workshop Manual (2006-2008)06 · Suspension
06 · Steering & suspension

Clip installation note

Make
Mazda
Model
MX-5 (NC) Factory Workshop Manual
Year
2006–2008
Section
Front Suspension › Clip installation note
SuspensionClip installation note

Fig. 22: Pressing Bushing In Using SSTs
Courtesy of MAZDA MOTORS CORP.

CLIP INSTALLATION NOTE

  1. Wipe the grease off the ball joint stud.
  2. Fill the inside of the new dust boot with grease.
  3. Install the dust boot to the ball joint.
  4. Install the clip using the SST .
  5. Verify that the clip is installed securely to the groove.
SUSPENSION – Front Suspension – figure
Fig. 23: Installing Dust Boot To Ball Joint
Courtesy of MAZDA MOTORS CORP.
  1. Wipe off any excess grease.

FRONT LOWER ARM INSTALLATION NOTE

  1. Install the front lower arm rear side bushing part horizontally.
  2. Install the front lower arm front side bushing part.

FRONT LOWER ARM INSPECTION

  1. Remove the front lower arm from the vehicle. (See FRONT LOWER ARM

Parts & tools for this job For 2006 Mazda MX-5

As an Amazon Associate we earn from qualifying purchases.