Workshop Manuals Factory service & repair Mazda
01 General information02 Engine03 Engine performance04 Transmission05 Driveline and axles06 Suspension07 Brakes08 Steering09 Restraints10 Heating and air conditioning11 Electrical12 Accessories and equipment13 Body and cab accessories
Mazda MX-5 (NC) Factory Workshop Manual (2006-2008)06 · Suspension
06 · Steering & suspension

Front upper arm inspection

Make
Mazda
Model
MX-5 (NC) Factory Workshop Manual
Year
2006–2008
Section
Front Suspension › Front upper arm inspection
SuspensionFront upper arm inspection

REMOVAL/INSTALLATION .)

  1. Inspect the front lower arm for bending or damage. If there is any malfunction, replace it.
  2. Inspect the ball joint for excessive play. If there is any malfunction, replace the front lower arm.
  3. Rotate the ball joint 5 times .
  4. Measure the ball-joint rotational torque using an Allen wrench and a torque wrench.

Front lower arm ball joint rotational torque

0.4-2.9 N.m {5-29 kgf.cm, 4-25 in.lbf}

SUSPENSION – Front Suspension – figure
Fig. 24: Measuring Ball-Joint Rotational Torque
Courtesy of MAZDA MOTORS CORP.

FRONT UPPER ARM INSPECTION

  1. Remove the front upper arm from the vehicle. (See FRONT UPPER ARM REMOVAL/INSTALLATION .)
  2. Inspect the front upper arm for bending or damage. If there is any malfunction, replace it.
  3. Inspect the ball joint for excessive play, and if there is any malfunction, replace the front upper arm.
  4. Rotate the ball joint 5 times .

Parts & tools for this job For 2006 Mazda MX-5

As an Amazon Associate we earn from qualifying purchases.