Workshop Manuals Factory service & repair Mazda
01 General information02 Engine03 Engine performance04 Transmission05 Driveline and axles06 Suspension07 Brakes08 Steering09 Restraints10 Heating and air conditioning11 Electrical12 Accessories and equipment13 Body and cab accessories
Mazda MX-5 (NC) Factory Workshop Manual (2006-2008)06 · Suspension
06 · Steering & suspension

Front shock absorber inspection

Make
Mazda
Model
MX-5 (NC) Factory Workshop Manual
Year
2006–2008
Section
Front Suspension › Front shock absorber inspection
SuspensionFront shock absorber inspection

See also: live page (the same text is also in the 2008 2.0L manual)

SUSPENSION – Front Suspension – figure
Fig. 7: Identifying Upper Spring Seat Stud Angle
Courtesy of MAZDA MOTORS CORP.

FRONT SHOCK ABSORBER INSPECTION

  1. Remove the front shock absorber.
  2. Inspect for damage and oil leakage.
  3. Compress and extend the shock absorber piston rod at least three times at a steady speed. From the fourth compression stroke, verify that the operational force does not change and that there is no unusual noise.
    • If there is any malfunction, replace the shock absorber.

FRONT SHOCK ABSORBER DISPOSAL

WARNING: Whenever drilling into a shock absorber, wear protective eye wear. The gas in the shock absorber is pressurized, and could spray metal chips into the eyes and face when drilling.

  1. Clamp the shock absorber on a flat surface.
  2. Drill a 2-3 mm {0.08-0.12 in} hole at a point 25 mm {0.98 in} from the bottom of the tube, so that the gas can escape.
  3. Turn the hole downwards.
  4. The oil can be collected by moving the piston rod several times up and down and cutting the tube at the end.
  5. Dispose of waste oil according to local waste disposal law.

Parts & tools for this job For 2006 Mazda MX-5

As an Amazon Associate we earn from qualifying purchases.