Workshop Manuals Factory service & repair Mazda
01 General information02 Engine03 Engine performance04 Transmission05 Driveline and axles06 Suspension07 Brakes08 Steering09 Restraints10 Heating and air conditioning11 Electrical12 Accessories and equipment13 Body and cab accessories
Mazda MX-5 (NC) Factory Workshop Manual (2006-2008)06 · Suspension
06 · Steering & suspension

Front stabilizer control link inspection

Make
Mazda
Model
MX-5 (NC) Factory Workshop Manual
Year
2006–2008
Section
Front Suspension › Front stabilizer control link inspection
SuspensionFront stabilizer control link inspection
SUSPENSION – Front Suspension – figure
Fig. 29: Aligning Outer Side Of Stabilizer Slide Stopper With Stabilizer Bushing
Courtesy of MAZDA MOTORS CORP.
  1. Install the stabilizer bracket.

FRONT STABILIZER CONTROL LINK INSPECTION

  1. Remove the stabilizer control link from the vehicle. (See FRONT STABILIZER REMOVAL/INSTALLATION .)
  2. Inspect the stabilizer control link for bending or damage. If there is any malfunction, replace it.
  3. Rotate the ball joint stud 10 times , and then rock it side to side 10 times .
  4. Measure the ball-joint rotational torque using an Allen wrench and a torque wrench.

Stabilizer control link ball joint rotational torque

0.2-2.0 N.m {3-20 kgf.cm, 2-17 in.lbf}

Parts & tools for this job For 2006 Mazda MX-5

As an Amazon Associate we earn from qualifying purchases.