Workshop Manuals Factory service & repair MG
01 Introduction02 General information03 General data, torque settings and capacities04 Maintenance05 Engine (K Series)06 Engine management (MEMS 3), fuel and emission systems07 Cooling system08 Manifolds and exhaust system09 Clutch10 Manual gearbox11 Automatic gearbox (Stepspeed Em-CVT)12 Drive shafts13 Steering14 Front suspension15 Rear suspension16 Brakes17 Restraint systems (SRS)18 Body19 Heating and ventilation20 Air conditioning21 Wipers and washers22 Electrical23 Instruments
MG TF Factory Workshop Manual (2002-2005)02 · General information
02 · General

Rear impacts

Make
MG
Model
TF Factory Workshop Manual
Year
2002–2005
Section
SRS precautions › Rear impacts
General informationRear impacts

Rear impacts

Rear impacts may cause the seat belt pre-tensioners to deploy. If this occurs, both pre-tensioner units must be replaced. In addition, the following components should be inspected for damage and replaced as necessary:

  • Seat frames
  • Seat belts (retractors, webbing, tongue latching and body anchorage points)
  • SRS DCU

Periodic replacement of SRS components

The performance of the propellants within airbags and pre-tensioners will deteriorate over a period of time. As a result, it is essential that the airbags and pre-tensioners are periodically replaced to maintain occupant safety. Airbags, seat belt pre-tensioners and the rotary coupler should be replaced at 15 year intervals.

Parts & tools for this job For 2002 MG TF

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.