Windshield Header Trim - Nissan 240SX 1991-1992 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 240SX Nissan 240SX 1991-92 Workshop Manual
- Section
- General › Windshield Header Trim - Nissan 240SX 1991-1992 Workshop Manual
Windshield Header Trim
WINDSHIELD HEADER TRIM
1-5
OUTER TRIM CAP
REMOVE
LOWER CONVERTIBLE TOP.
1.
REMOVE RETAINER AT TOP OF EACH “A” PILLAR
2.
SECURING WEATHERSTRIP.
DETACH FRONT HEADER WEATHERSTRIP FROM
RETAINER. Using a suitable release agent (3M P/N 051135-08971 or equivalent) and a flat-bladed tool, remove weatherstrip from retainer.
NOTE: ONLY remove front header weatherstrip from front header weatherstrip retainer.
REMOVE FRONT HEADER LATCH RECEIVERS.
(a) Remove two (2) screws and latch receiver. (b) Repeat step (a) on other side of vehicle.
REMOVE HEADER OUTER TRIM CAP.
(a) Hold weatherstrip material up from retainer and remove nine (9) screws.
NOTE: Do not pull weatherstrip so as to disturb weatherstrip-to-header adhesive tape seal. (b) Pull outer trim cap, with retainer attached, from windshield header.
DETACH WEATHERSTRIP RETAINER FROM OUTER TRIM
CAP. (a) Using a suitable release agent (8M P/N 051135-08971 or equivalent) separate retainer from outer trim cap. (ob) Clean any traces of foam tape from weatherstrip retainer.
Parts & tools for this job For Nissan 240SX
- TOOLTrim removal tool kitSearch: trim removal tool kit
- PARTTouch-up paintSearch: Nissan touch up paint
- PARTPanel clip assortmentSearch: Nissan panel clips assortment
As an Amazon Associate we earn from qualifying purchases.