Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual06 · Windshield Header Trim
06 · Body & interior

Windshield Header Trim - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › Windshield Header Trim - Nissan 240SX 1991-1992 Workshop Manual
Windshield Header TrimWindshield Header Trim - Nissan 240SX 1991-1992 Workshop Manual

Windshield Header Trim

WINDSHIELD HEADER TRIM

1-9

MIRROR ATTACHING BUTTON (cont'd)

5.

PREPARE REAR VIEW MIRROR ATTACHING BUTTON.

(a) Using a piece of fine grit (340X or 360X) emery cloth or sandpaper, sand the bonding surface of the rear view mirror attaching button.

NOTE: If the original attaching button is to be reused, all traces of the factory installed adhesive must be removed prior to installation. (b) Clean the button sanded surface with alcohol and tet dry.

6.

INSTALL REAR VIEW MIRROR ATTACHING BUTTON.

Lightly apply adhesive accelerator to bonding surfaces of attaching button and windshield. Allow adhesive accelerator to dry completely. Apply two (2) drops of adhesive to attaching button bonding surface. Using a toothpick, evenly distribute adhesive over entire bonding surface of attaching button. With attaching button rounded end pointing up, position button to pre-marked location on windshield. Firmly press attaching button against windshield for 30 to 60 seconds. After five minutes, remove any excess adhesive with an alcohol-moistened paper towel and a single-edge razor blade.

7. INSTALL INNER REAR VIEW MIRROR, (See Inner Rear View Mirror in this chapter).

8. INSTALL WINDSHIELD HEADER GARNISH MOLDING, (See Windshield Garnish Molding in this chapter).

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.