Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual06 · Windshield Header Trim
06 · Body & interior

Windshield Header Trim - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › Windshield Header Trim - Nissan 240SX 1991-1992 Workshop Manual
Windshield Header TrimWindshield Header Trim - Nissan 240SX 1991-1992 Workshop Manual

Windshield Header Trim

WINDSHIELD HEADER TRIM

1-7

INNER REAR VIEW MIRROR

REMOVE

1. REMOVE WINDSHIELD HEADER GARNISH MOLDING (See Windshield Garnish Molding in this chapter).

2.

REMOVE REAR VIEW MIRROR WIRE COVER.

Grasp wire cover, pull upward and remove.

3.

REMOVE INNER REAR VIEW MIRROR.

(a) Disconnect wire harness connector.

(b) Loosen set screw and remove mirror.

INSTALL

1.

INSTALL INNER REAR VIEW MIRROR.

(a) Position mirror to button and tighten set screw. Torque: 1.5 Nm (13 in. tb.)

(b) Connect wire harness connector.

NOTE: Wire harness connector must be wrapped with foam tape to prevent rattles.

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.