Windshield Header Trim - Nissan 240SX 1991-1992 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 240SX Nissan 240SX 1991-92 Workshop Manual
- Section
- General › Windshield Header Trim - Nissan 240SX 1991-1992 Workshop Manual
Windshield Header Trim
WINDSHIELD HEADER TRIM
1-8
INNER REAR VIEW MIRROR (con't)
INSTALL REAR VIEW MIRROR WIRE COVER.
2.
INSTALL WINDSHIELD HEADER GARNISH MOLDING, (See
3. Windshield Garnish Malding in this chapter.
MIRROR ATTACHING BUTTON
INSTALL REMOVE WINDSHIELD HEADER GARNISH MOLDING, (See
4. Windshield Garnish Molding in this chapter.
REMOVE BUTTON FROM INNER REAR VIEW MIRROR IF IT
2.
IS TO BE REUSED.
Loosen set screw and remove button from mirror.
DETERMINE REAR VIEW MIRROR BUTTON LOCATION.
3. a 1 Nah Measure and mark, 150 mm (5-7/8 in.) down from top of windshield. 4 5 7/8 in. (150mm)
Measure across windshield and draw a small circle (2 in.
(b) | dia.) where lines intersect. t
CLEAN REAR VIEW MIRROR BUTTON LOCATION.
4. Clean circled area of windshield, inside surface, with glass (a) cleaning solution and allow to dry. Clean area with alcohol to remove any traces of cleaning (b) solution.
A BUTTON LOCATING CIRCLE
B CLEANING AREA
C BUTTON BASE LINE
1 WINDSHIELD
2 REAR VIEW MIRROR BUTTON
Parts & tools for this job For Nissan 240SX
- TOOLTrim removal tool kitSearch: trim removal tool kit
- PARTTouch-up paintSearch: Nissan touch up paint
- PARTPanel clip assortmentSearch: Nissan panel clips assortment
As an Amazon Associate we earn from qualifying purchases.