Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual06 · Windshield Header Trim
06 · Body & interior

Windshield Header Trim - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › Windshield Header Trim - Nissan 240SX 1991-1992 Workshop Manual
Windshield Header TrimWindshield Header Trim - Nissan 240SX 1991-1992 Workshop Manual

Windshield Header Trim

WINDSHIELD HEADER TRIM

1-6

OUTER TRIM CAP (cont'd)

INSTALL

ATTACH WEATHERSTRIP RETAINER TO OUTER TRIM CAP.

1. Apply foam tape to bottom of weatherstrip retainer. (a) Align weatherstrip retainer mounting holes with outer trim (b) cap holes and press together.

INSTALL HEADER OUTER TRIM CAP.

Starting at one end, hold weatherstrip up while inserting (a) outer irim cap and retainer.

NOTE: Do not pull weatherstrip so as to disturb weatherstrip-to-header adhesive tape seal. Hold weatherstrip up from retainer and install nine (9) (b) screws.

INSTALL FRONT HEADER LATCH RECEIVERS.

3. Position latch receiver (round base left side, slotted base (a) right side) to header. Secure latch receivers using two (2) screws each. (b)

APPLY ADHESIVE TO FRONT HEADER WEATHERSTRIP

4. RETAINER. Apply a continuous bead of adhesive (3M P/N 051135-08008 or equivalent) to the front weatherstrip retainer.

NOTE: Insure weatherstrip adhesive fills void at center of weatherstrip mounting surface.

INSTALL FRONT HEADER WEATHERSTRIP.

5. Secure weatherstrip ends to top of "A" pillars using (a) retainers (push pins). Starting at ends, then working toward center, install (b) weatherstrip to retainer using a flat-bladed tool.

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.