Pre-tensioner - front seat belt (page 2 of 2)

Refit

1. Position pre-tensioner to ’B’ post, fit bolts and tighten to; M10 = 32 Nm M5 = 10 Nm
2. Extend belt from reel and attach to upper mounting point, tighten bolt to 32 Nm and fit cover.
3. Ensure belt is fitted under ’B’ post upper finisher and fit finisher clip.
4. Position belt to lower mounting point, tighten bolt to 32 Nm. Fit bolt cover.
5. Disengage the seat belt tensioner sensor lock.

WARNING: Take care not to apply any impacts to the seat belt tensioner, once the sensor lock has been disengaged.

6. Fit ’B’ post lower finisher. See BODY, Interior trim components.
7. Connect battery earth lead.