Workshop Manuals Factory service & repair Rover
01 Introduction02 General information03 Information04 Maintenance05 Engine - K Series06 Engine - D Series07 Engine - L Series08 Engine - T Series09 Emission control10 Engine management system - MEMS11 Engine management system - PGMFi12 Engine management system - EDC13 Fuel delivery system14 Cooling system15 Cooling system - L Series16 Manifold & exhaust systems17 Clutch18 Manual gearbox - R6519 Manual gearbox - PG120 Automatic gearbox21 Drive shafts22 Steering23 Suspension24 Brakes25 Restraint systems26 Body27 Heating & ventilation28 Air conditioning29 Wipers & washers30 Electrical31 Instruments
Rover 400 Workshop Manual (1995-2000)20 · Automatic gearbox
20 · Transmission

Lock-up with D4 selected

Make
Rover
Model
400 Workshop Manual
Year
1995–2000
Section
Fault diagnosis › Lock-up with D4 selected
Automatic gearboxLock-up with D4 selected

Lock-up with D4 selected

Throttle positionLock-up ONLock-up OFF
Closed throttle - slight downhill gradient mph kph15 to 17 24 to 2714 to 16 23 to 26
Full throttle mph kph88 to 91 141 to 14784 to 88 135 to 141

Lock-up - D3 selected

Throttle positionLock-up ONLock-up OFF
Closed throttle - slight downhill gradient mph kph60 to 64 97 to 10357 to 61 92 to 98
Full throttle mph kph82 to 86 132 to 13878 to 81 125 to 131
  1. Accelerate to approximately 35 mph, 57 kph then select 2 from D4; vehicle should immediately reduce speed under engine braking.

CAUTION: Do not select 2 or 1 from D4 or D3 at speeds in excess of 63 mph, 100 kph, damage to the gearbox may result.

  1. Check for any abnormal noises or clutch slippage with selector in following positions: Select 1 Accelerate from standstill at full throttle, upshifts should not occur. Select 2 Accelerate from standstill at full throttle, upshifts or downshifts should occur. Select R Carry out a reversing manoeuvre. Accelerate from stop at full throttle, check for abnormal noise and clutch slippage. Check park - P Position vehicle on a steep gradient (12%), apply the handbrake and with engine still running, select P. Release the handbrake, vehicle should not move.
  2. On completion of a road test, carry out a stall test.

Parts & tools for this job For 1995 Rover 400

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.