Workshop Manuals Factory service & repair Rover
01 Introduction02 General information03 Information04 Maintenance05 Engine - K Series06 Engine - D Series07 Engine - L Series08 Engine - T Series09 Emission control10 Engine management system - MEMS11 Engine management system - PGMFi12 Engine management system - EDC13 Fuel delivery system14 Cooling system15 Cooling system - L Series16 Manifold & exhaust systems17 Clutch18 Manual gearbox - R6519 Manual gearbox - PG120 Automatic gearbox21 Drive shafts22 Steering23 Suspension24 Brakes25 Restraint systems26 Body27 Heating & ventilation28 Air conditioning29 Wipers & washers30 Electrical31 Instruments
Rover 400 Workshop Manual (1995-2000)18 · Manual gearbox - R65
18 · Transmission

Manual gearbox (page 4 of 5)

Make
Rover
Model
400 Workshop Manual
Year
1995–2000
Section
Repairs
Manual gearbox - R65Manual gearbox · page 4 of 5
Diagram
  1. Release charcoal canister from mounting bracket and position aside.
  2. Loosen through bolt securing gearbox mounting to body.
  3. Remove 2 bolts securing mounting bracket to gearbox.
Remove 2 bolts securing mounting bracket to gearbox.
  1. Remove 2 bolts securing LH torque mounting to body.
  2. Fit wooden block to jack and position jack to support engine.
Fit wooden block to jack and position jack to support engine.
  1. Remove bolt securing air conditioning pipe to bracket.
  2. Models with air conditioning: Remove 2 bolts securing air conditioning pipe bracket to engine and gearbox.
Models with air conditioning: Remove 2 bolts securing air conditioning pipe bracket to eng
  1. Remove 2 lower bolts securing gearbox to engine.
  2. Using assistance, release gearbox from engine.
  3. Manoeuvre gearbox from engine and lower from vehicle.
  4. Disconnect lifting equipment from gearbox and remove gearbox from beneath vehicle.

Parts & tools for this job For 1995 Rover 400

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.