Workshop Manuals Factory service & repair SEAT
01 Power transmission02 Running gear03 Body04 Power tramsmission05 Power unit06 Vehicle electrics07 Heating-ventilation-air conditioning system08 Automatic gearbox09 Engine, mixture preparation10 Engine, mechanics11 Manual gearbox12 Running gear - self diagnosis13 Heating and air conditioning14 Bodywork15 Heating, ventilation, air conditioning system
SEAT Leon Mk101 · Power transmission
01 · Transmission

Renewing input shaft seal

Make
SEAT
Model
Leon Mk1
Section
Gearbox,mechanics,gears,shafts,internal operation › Input shaft: › Renewing input shaft seal
Power transmissionRenewing input shaft seal
Renewing input shaft seal
Consult the equivalence table for tools and equipment according to applicability among Seat / VW / Audi / Skoda → Chapter.
Special tools and workshop equipment required
   
t  Pressing-off lever -T20143/1-
  W00-2958
t  pressure tool -T40008-
t  Grease -G 052 128 A1-
Operation process
–  Remove gearbox.
–  Remove clutch release lever with release bearing and guide sleeve → Chapter
–  Lever out seal for input shaft using lever -T20143/1-.
Renewing input shaft seal – SEAT Leon Mk1  Note
Do not damage running surface of input shaft for oil seal.
  W00-1002
–  Pack space between sealing lip and dust lip -arrow- half-full with sealing grease -G 052 128 A1-.
–  Lightly moisten outer circumference of oil seal with gear oil.
  N32-0001
Driving in input shaft oil seal flush
–  Install clutch release lever with release bearing and guide sleeve → Chapter
–  Install gearbox.
  A34-0309

The same page in: Leon Mk2.

Parts & tools for this job For SEAT Leon

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.