Workshop Manuals Factory service & repair SEAT
01 Power transmission02 Running gear03 Body04 Power tramsmission05 Power unit06 Vehicle electrics07 Heating-ventilation-air conditioning system08 Automatic gearbox09 Engine, mixture preparation10 Engine, mechanics11 Manual gearbox12 Running gear - self diagnosis13 Heating and air conditioning14 Bodywork15 Heating, ventilation, air conditioning system
SEAT Leon Mk102 · Running gear
02 · Steering & suspension

Brake pedal

Make
SEAT
Model
Leon Mk1
Section
Brake system › Brake, brake mechanics › Brake pedal
Running gearBrake pedal
Brake pedal, vehicles with the steering wheel on the left - assembly overview
Brake pedal – SEAT Leon Mk1   WARNING
The brake pedal stroke must not be obstructed by fitting extra coverings to the footwell.
   
Brake pedal – SEAT Leon Mk1
1 - Support buck
2 - Hexagon nut, 25 Nm
3 - Brake light switch -F- and brake pedal switch -F47-
q   In vehicles manufactured from week 45/05, the brake pedal position sender -G100- is located on the brake pump → Chapter
q   Before fitting the brake light switch -F- and brake pedal switch -F47- insert the brake pedal with the push rod into the servo brake
q   Removing, installing and adjusting → Chapter
q   Before fitting, grease the rod with grease according to the → Parts catalogue
4 - Hexagon bolt
5 - Brake pedal
q   Removing and installing → Chapter
q   separate from servo brake → Chapter.
q   Before fitting, grease the contact surfaces with grease → Parts catalogue
6 - Trim upholstery
7 - Ball socket
8 - Mounting
q   For the spherical head of the servo-brake control rod
9 - Hexagon nut, 25 Nm
10 - Sleeve bearing
q   Before fitting, grease the bearing bush surfaces with grease → Parts catalogue
11 - Pivot pin

   

The same page in: Leon Mk2.

Parts & tools for this job For SEAT Leon

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.