Removing and installing bracket

Make

Skoda

Model

Fabia Mk1

Section

Steering › Frequency link, bracket › Removing and installing bracket

Running gearRemoving and installing bracket

Removing and installing bracket Removing: –  Removing the dash panel → Body Work; Rep. gr.70. –  Removing the steering column → Chapter.   Note The surrounding components are not shown to simplify the illustrations.

–  Remove frequency link -1- from the bracket -3-. –  Remove screw -2-.

–  Release screws -3-. –  Unscrew screws -2- and remove bracket -1-. 4 -  Central pipe Installing:   Note t  Screws -2- and -3- are identical and are tightened to the same torque. t  When installing the bracket -1- observe the mounting sequence of the screws -2- and -3-. –  Position the bearing bracket -1- at the central pipe -4-. –  Screw in screws -2- and initially tighten to 5 Nm (do not fully tighten the screws yet). –  Insert and tighten screws -3-. –  Tighten the screws -2- to the specified tightening torque. Further installation occurs in reverse order.

Tightening torques:

Bracket to central pipe	23 Nm
Frequency link to bracket	23 Nm

01 Steering & suspension