Disassembling and assembling the reverse shaft

Make

Skoda

Model

Fabia Mk1

Section

Gearbox 02R › Gearbox,mechanics,gears,shafts,internal operation › Disassembling and assembling the reverse shaft

Power transmissionDisassembling and assembling the reverse shaft

Disassembling and assembling the reverse shaft Special tools and workshop equipment required t  Pressure plate -MP 3-406- t  Pressure plate - MP 3-411- t  Thrust piece -MP 3-423- t  Thrust piece -MP 3-448- t  Thrust piece -MP 3-449- t  Thrust washer -MP 3-455- t  Centering mandrel -MP 3-463- t  Interior extractor, e.g. -Kukko 21/2- t  Countersupport, e.g. -Kukko 22/1 -

1 -	Clutch housing

2 -	Needle bushing

q	removing → Fig.

q	installing → Fig.

q	always replace after removing → Electronic Catalogue of Original Parts

3 -	Reverse pinion

4 -

Circlip

q	always replace after removing → Electronic Catalogue of Original Parts

5 -	Reverse gear sliding gear

q	remove circlip before replacing

q	collar points to reverse gear pinion

6 -	Reverse shaft

q	removing → Chapter

7 -	Needle bushing

q	pressing out → Fig.

q	installing → Fig.

q	always replace after removing → Electronic Catalogue of Original Parts

8 -	reverse shaft support

q	removing and installing → Chapter

Removing needle bushing from clutch housing A -  Countersupport, e.g. -Kukko 22/1- B -  Interior extractor 14.5 up to 18.5 mm, e.g. -Kukko 21/2-   Note The needle bushing is damaged when removed and must be replaced → Electronic Catalogue of Original Parts.

Pressing in needle bushing -A- in the clutch housing

Pressing out needle bushing from the reverse shaft support

Pressing the needle bushing in the reverse shaft support

06 Transmission