Setting drive shaft

Make

Skoda

Model

Fabia Mk1

Section

Gearbox 02R › Gearbox,mechanics,gears,shafts,internal operation › Setting drive shaft

Power transmissionSetting drive shaft

Setting drive shaft (Determine adjusting washer for drive shaft) Special tools and workshop equipment required t  Gauge block plate -MP 3-405/17 - t  Thrust washer -MP 3-413- t  Thrust piece -MP 3-423- t  Universal dial gauge holder -MP 3-447- t  Thrust washer -MP 3-456- t  Gearbox mount -MP 3-501- The drive shaft must be reset, if it has been replaced: t  Gearbox housing t  Clutch housing t  Drive shaft t  4th gear pinion or the t  Tapered-roller bearing Setting overview: → Chapter –  Press outer ring/tapered-roller bearing into the clutch housing up to the stop → Chapter

–  Press outer ring/tapered-roller bearing into the gearbox housing up to the stop without adjusting washer with pressure washer -MP 3-413- –  Insert drive shaft in the clutch housing and install gearbox housing. Tighten screws to tightening torque → Chapter.

–  Fit measuring device and dial gauge in the clutch housing. –  Turn the drive shaft a number of times before measuring to ensure the tapered-roller bearing sets. Set the dial gauge to “0” with 1 mm bias.   Note This procedure must be repeated before each subsequent measurement as the dial gauge does not return to is initial setting (0) without turning. –  Press drive shaft towards the dial gauge -direction of arrow-. –  Read of play on dial gauge and note (example: 1.21).   Note Dial gauge does not return to initial position. –  Determine the adjusting washer thickness from the table → Chapter (example: 1.175). –  Remove drive shaft and press out outer ring/tapered-roller bearing from the gearbox housing with thrust washer -MP 456-. –  Press outer ring/tapered-roller bearing into the gearbox housing with thrust washer -MP 3-413 - and with adjusting wahser 1.175. –  Position the gearbox housing and tighten screws to the given tightening torque → Chapter.

06 Transmission