Radio

Make

Skoda

Model

Superb

Section

Electrical System › Infotainment › Radio

Vehicle electricsRadio

Removing and installing radio Special tools and workshop equipment required t  Release tool for radio -T10057- t  Release tool for radio -T30005- Removing Diagram not available  Note t  The anti-theft code should most certainly be activated if the radio with anti-theft code is replaced ( → Operating instructions for the radio). The new code number must be advised to the customer. t  Remove radio “Gamma” using the release tool -T10057- and remove radio “Grundig MS 303” and “Symphony” using the release tool -T30005-. t  Removal and installation of the radio “Rhapsody” is identical to the removal and installation of the radio navigation device → Chapter.

–  Position the release tool in the release slot, as shown, until it clicks into position. –  Remove radio from the dash panel using the grab rings on the release tool. Diagram not available  Note t  Do not press aside or twist release tool -T30005- or -T10057- during these operations. t  In order to pull off the release tool, press in the side catches at the radio set. –  Separate antenna cable and plug connections. Install –  Attach the aerial cable to the radio. –  Mount plug. –  Carefully insert radio into dash panel until it locks in the installation slot. If the radio was replaced: –  Enter safety code, see → Operating instructions for the radio. –  Code the radio → Vehicle diagnosis, testing and information system VAS 5051.

07 General