2.REPLACE EXHAUST VALVE GUIDE BUSH - Toyota Hilux AN120/AN130 2015-2018 Workshop Manual
- Make
- Toyota
- Model
- Hilux Toyota Hilux AN120/AN130 2015-2018 Workshop Manual
- Section
- REPLACEMENT › 2.REPLACE EXHAUST VALVE GUIDE BUSH - Toyota Hilux AN120/AN130 2015-2018 Workshop Manual
2.REPLACE EXHAUST VALVE GUIDE BUSH

h.

Using SST and a hammer, tap in a new intake valve guide bush to the specified protrusion height. SST 09201-10000 (09201-01060) 09950-70010 (09951-07100) Standard protrusion height (H):
15.5 to 15.9 mm (0.610 to 0.626 in.)
i.

*a Sharp 6.0 mm Reamer
Using a sharp 6.0 mm reamer, ream the intake valve guide bush to obtain the standard specified clearance between the intake valve guide bush and intake valve stem. Standard oil clearance:
0.025 to 0.060 mm (0.000984 to 0.00236 in.)
2.REPLACE EXHAUST VALVE GUIDE BUSH
a. Heat the cylinder head sub-assembly to approximately 80 to 100°C (176 to 212°F).
CAUTION: Be sure to wear protective gloves.
b. Place the cylinder head sub-assembly on wooden blocks.
Parts & tools for this job For Toyota Hilux
- PARTExhaust gasketSearch: Toyota Hilux exhaust gasket
- TOOLPenetrating oilSearch: penetrating oil
- TOOLOBD2 scannerSearch: OBD2 scanner
As an Amazon Associate we earn from qualifying purchases.