3.REPLACE RING PIN - Toyota Hilux AN120/AN130 2015-2018 Workshop Manual
- Make
- Toyota
- Model
- Hilux Toyota Hilux AN120/AN130 2015-2018 Workshop Manual
- Section
- REPLACEMENT › 3.REPLACE RING PIN - Toyota Hilux AN120/AN130 2015-2018 Workshop Manual
3.REPLACE RING PIN
09950-70010 (09951-07100) Standard protrusion height (H):

15.5 to 15.9 mm (0.610 to 0.626 in.)
i.

*a Sharp 6.0 mm Reamer
Using a sharp 6.0 mm reamer, ream the exhaust valve guide bush to obtain the standard specified clearance between the exhaust valve guide bush and exhaust valve stem. Standard oil clearance:
0.035 to 0.070 mm (0.00138 to 0.00276 in.)
3.REPLACE RING PIN
NOTICE: It is not necessary to remove the ring pin unless it is being replaced.
a. Remove the ring pin from the cylinder head sub-assembly.
b.

*a Protrusion Height
Using a plastic-faced hammer, tap in new ring pins to the cylinder head sub-assembly. Standard protrusion height:
3.5 to 4.5 mm (0.138 to 0.177 in.)
Parts & tools for this job For Toyota Hilux
- PARTEngine gasket setSearch: Toyota Hilux engine gasket set
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLFeeler gauge setSearch: feeler gauge set
As an Amazon Associate we earn from qualifying purchases.