4.REPLACE STRAIGHT PIN - Toyota Hilux AN120/AN130 2015-2018 Workshop Manual
- Make
- Toyota
- Model
- Hilux Toyota Hilux AN120/AN130 2015-2018 Workshop Manual
- Section
- REPLACEMENT › 4.REPLACE STRAIGHT PIN - Toyota Hilux AN120/AN130 2015-2018 Workshop Manual
‹ Prev 3.REPLACE RING PIN - Toyota Hilux AN120/AN130 2015-2018 Workshop ManualNext › DRIVE BELT - COMPONENTS - Toyota Hilux AN120/AN130 2015-2018 Workshop Manual
CYLINDER HEAD4.REPLACE STRAIGHT PIN - Toyota Hilux AN120/AN130 2015-2018 Workshop Manual
4.REPLACE STRAIGHT PIN
4.REPLACE STRAIGHT PIN
NOTICE: It is not necessary to remove the straight pin unless it is being replaced.
a. Remove the straight pin from the cylinder head sub-assembly.
b.

*a Protrusion Height
Using a plastic-faced hammer, tap in new straight pins to the cylinder head sub-assembly. Standard protrusion height:
2.0 to 4.0 mm (0.0787 to 0.157 in.)
‹ Prev 3.REPLACE RING PIN - Toyota Hilux AN120/AN130 2015-2018 Workshop ManualNext › DRIVE BELT - COMPONENTS - Toyota Hilux AN120/AN130 2015-2018 Workshop Manual
Parts & tools for this job For Toyota Hilux
- PARTEngine gasket setSearch: Toyota Hilux engine gasket set
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLFeeler gauge setSearch: feeler gauge set
As an Amazon Associate we earn from qualifying purchases.