DTC B2625 02: Display Dimming Pulse Width
Modulation Output Circuit Short to Ground
Diagnostic Fault Information
Circuit
Short to Ground
Open/High Resistance
Short to Voltage
Signal Performance
Display Dimming Control
B2625 02
2
1
-
1. Switch illuminated when switched features Not Activated.
2. Switch do not illuminate when switched features Activated.
Circuit/System Description
The body control module (BCM) supplies a reference voltage to
the backlight dimmer switch, which is part of the headlamp switch.
When the backlight dimmer switch is placed in a desired brightness
position, reference voltage is applied through the backlight dimmer
switch rheostat to the BCM. The BCM interprets this voltage signal,
then applies a pulse width modulated (PWM) voltage to the backlight
lamp control circuit, and the LED dimming control circuit
illuminating the LEDs of the components listed below, if
equipped:
•
Tour mode switch
•
Sport mode switch
•
Park assist switch
•
Vehicle direction camera
switch
Conditions for Running the DTC
The ignition is ON.
Conditions for Setting the DTC
The BCM detects a short to ground on the LED dimming control
circuit.
Action Taken When the DTC Sets
The BCM will not attempt to illuminate the LED indicator lamps
when a short circuit to ground is detected.
Conditions for Clearing the DTC
•
The condition responsible for
setting the DTC no longer exists.
•
A history DTC will clear once
100 consecutive malfunction ignition cycles have occurred.
Ignition ON, switch ON exterior lighting, vary the interior
backlight from dim to full bright by using the dimmer switch. The
LED of the following components should dim and then become full
bright again, if equipped:
•
Tour mode switch
•
Sport mode switch
•
Park assist switch
•
Vehicle direction camera
switch
Circuit/System Testing
Tour Mode and Sport Mode Switch Malfunction
1.
Ignition OFF, disconnect the
harness connector at the appropriate inoperative switch.
2.
Ignition ON, verify that a
test lamp illuminates between the LED control circuit terminal 6
and ground.
⇒
If the test lamp does not illuminate, test the
control circuit for a short to ground or open/high resistance. If
the circuit tests normal, replace the K9 Body Control Module.
⇒
If the test lamp illuminates, test the ground
circuit for a short to voltage or open/high resistance. If the
circuit tests normal, replace the appropriate inoperative
switch.
Parking Assist Switch and Vehicle Direction Camera Switch
1.
Ignition OFF, disconnect the
harness connector at the S48D Multifunction Switch 2 - Instrument
Panel.
2.
Ignition ON, verify that a
test lamp illuminates between the LED control circuit and terminal
3 and ground.
⇒
If the test lamp does not illuminate, test the
control circuit for a short to ground or open/high resistance. If
the circuit tests normal, replace the K9 Body Control Module.
⇒
If the test lamp illuminates, test the appropriate
ground circuit for a short to voltage or open/high resistance. If
the circuit tests normal, replace the S48D Multifunction Switch 2 -
Instrument Panel
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.
Help keep workshop manuals free
workshop-manuals.com provides free online workshop manuals.
If they helped you fix your car, please consider sharing or
making a small donation to keep the servers running.