- Corsa D Workshop Manual
- General Vehicle Information
- A Maintenance, Body and Chassis Sheet Metal Parts, Frame
- B Paint
- C Body Equipment
- D Heating, Ventilation, Air Conditioning (HVAC)
- E Front Wheel Suspension, Wheels and Tyres
- F Rear Axle and Rear Wheel Suspension
- H Brakes
- J Engine and Engine Aggregates
- Repair Instructions
- Other Information
- Technical Service Bulletins
- Technical Information
- DOHC Petrol Engine
- Fuel Injection Systems
- Engine Electrics
- Cooling System
- Turbo-Charging
- DOHC diesel engine
- Repair Instructions
- General
- Seals and Seal Rings
- Ribbed V-Belt
- Fuel Pump
- Engine Damping Block
- Oil Circulating
- Timing Gear Case
- Cylinder Block
- Cylinder Head
- Repair Instructions
- Attaching Parts - Cylinder Head, Remove and Install
- Replace exhaust gas recirculation valve
- Engine cover, remove and install
- Cylinder Head, Check for Plane Surface
- Cylinder Head, Remove and Install
- Cup Tappets, Replace
- Cylinder Head, Remove and Install
- Cylinder Head, Check for Plane Surface
- Detaching and attaching components, cylinder head
- Replace exhaust gas recirculation valve
- Replace exhaust gas recirculation cooler
- Engine cover, remove and install
- Cylinder Head, Remove and Install
- Attaching Parts - Cylinder Head, Remove and Install
- Cylinder Head, Check for Plane Surface
- Replace exhaust gas recirculation valve
- Replace EGR radiator
- Replace exhaust gas recirculation valve (M20-6 MTA transmission)
- Replace cooer, exhaust gas recirculation valve
- Cylinder head and attaching parts, check and measure - Survey
- Cylinder head height, check
- Cylinder head, check for plane surface
- Valve, measure
- Inner diameter of valve guide, check
- Valve stem play, determine
- Installation height of valves, check
- Installation height of valve guide, check
- Cylinder head, overhaul
- Cylinder head, attach to assembly tool set KM-6215
- Cylinder head, disassemble
- Valves, remove
- Valve seat, cut (in cylinder head)
- Valve guide, ream
- Valve, grind
- Valve, grind in
- Valve stem seals, replace
- Cylinder head, assemble
- Cylinder head machining table of contents
- Specifications
- Special Tools and Equipment
- Hydraulic Valve Lifter
- Camshaft
- Camshaft Housing
- Valves
- Intake manifold
- Exhaust manifold
- Glow plugs
- Vacuum Pump
- Auxiliary aggregate drive
- Toothed Belt
- Stop/Start System
- K Clutch and Transmission
- L Fuel and Exhaust System
- M Steering
- N Electrical Equipment and Instruments
- R Accessories