Workshop Manuals Factory service & repair

Alfa Romeo Brera and Spider Factory Service Manual (2005-2010)23 · Fault diagnosis

23 · Diagnostics

Teg lock warning light on constantly

Make: Alfa Romeo
Model: Brera and Spider Factory Service Manual
Year: 2005–2010
Section: Instrument panel › Teg lock warning light on constantly

‹ Prev Engine oil temperature gauge not working Next › Teg lock warning light not working

Fault diagnosisTeg lock warning light on constantly

TEG LOCK WARNING LIGHT ON CONSTANTLY

1	PRELIMINARY CHECKS	ALL OK	PROBLEMS ENCOUNTERED	ACTION
	Check that the engine has not been switched off by pressing the Start/Stop button with the vehicle speed above 10 km/h Check that the ignition key has not been released with the insert.	Move on to Step 2	1.The engine has been switched off with the vehicle speed above 10 km/h	1.Delete the errors at the Teg Reader Node using the Examiner
			2.The engine has not been switched off	2.Move on to step 4
			3.The ignition key has been released.	3.Continue following See table B006 KEY CANNOT BE EXTRACTED FROM BLOCK
			4.The ignition key has not been released.	4.Move on to step 4
2	CHECK USING DIAGNOSTIC EQUIPMENT	ALL OK	PROBLEMS ENCOUNTERED	ACTION
	Using the Examiner check, in the Instrument Panel Node ambient, that there are no errors and that the parameters are present.	Move on to Step 3	Errors present	Continue as described by the diagnostic equipment
3	ACTIVE DIAGNOSIS CHECK	ALL OK	PROBLEMS ENCOUNTERED	ACTION
	With the Examiner in the Instrument Panel Node ambient check that the Teg Locked warning light is correctly activated in Active Diagnosis	Move on to Step 4	The warning light does not flash	Replace the Instrument Panel Op. 5560B10 CONTROL PANEL - R+R
4	CHECK USING DIAGNOSTIC EQUIPMENT	ALL OK	PROBLEMS ENCOUNTERED	ACTION
	Check that there are no errors with the Examiner connected at the Teg Reader node.	Move on to Step 5	Errors present	Continue as described by the diagnostic equipment
5	START/STOP BUTTON OPERATION CHECK	ALL OK	PROBLEMS ENCOUNTERED	ACTION
	Check that the Start/Stop button is working properly by carrying out See Test 5520GA IGNITION PUSH BUTTON CHECK	End of diagnosis	Start/Stop button defective	Replace the starting button Op. 5520G30 START/STOP SWITCH FOR EASY-GO SYSTEM STARTER MOTOR - R.R.

‹ Prev Engine oil temperature gauge not working Next › Teg lock warning light not working

Parts & tools for this job For 2005 Alfa Romeo Brera

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.