MMI infotainment system

Make

Audi

Model

A5

Section

Communication › Infotainment › MMI infotainment system

Vehicle electricsMMI infotainment system

Removing and installing radio -R- (MMI from week 45/08 onwards) The radio -R- is located behind the luggage compartment side trim (left-side). Special tools and workshop equipment required

t  Protective cap for cable connector -VAS 6223/9- –  Switch off all electrical equipment. –  Remove ignition key. –  When renewing control unit, select „Replacement“ function for appropriate control unit in „Guided Fault Finding“. To do so, use → Vehicle diagnostic tester. Removing First remove the infotainment rack. If a digital sound package control unit -J525- is installed, it must be removed together with the bracket. –  Open left-side luggage compartment storage area. –  Release and unplug connectors at digital sound package control unit -J525-.

–  Fit protective cap for cable connector -VAS 6223/9--1- onto MOST bus connector -2-.

–  Unscrew nuts -1- and bolts -3- from bracket -2- and lift bracket with digital sound package control unit -J525- into luggage compartment.

–  Unscrew nuts -1-, -2- and -4- on infotainment rack -3-. –  Pivot infotainment rack -3- into luggage compartment. Unplug any connectors that are in the way. –  Release and unplug connectors at radio -R-.

–  Fit protective cap for cable connector -VAS 6223/9--1- onto MOST bus connector -2-.

–  Push the two tabs -arrows- (left and right) on radio -R- and pull radio -R--arrow- out of infotainment rack. Installing –  Install in reverse sequence of removal. Tightening torques → Chapter

05 General