Workshop Manuals Factory service & repair Fiat
01 General information02 Specifications03 Manufacturing data and tolerances04 Tightening torques05 Fluids and lubricants06 Maintenance07 Diagnostic checks08 Engine09 Clutch10 Gearbox and differential11 Axles and driveshafts12 Brakes13 Steering14 Suspension and wheels15 Heating, air conditioning and auxiliary units16 Electrical equipment17 Body fittings18 Body panels and frame19 Wiring diagrams and electrical functions20 Wiring harnesses21 Connectors and pin-outs22 Fault diagnosis23 Special tools
Fiat Bravo Factory Service Manual (2007-2014)17 · Body fittings
17 · Body & interior

Rear bumper centre mount - r r

Make
Fiat
Model
Bravo Factory Service Manual
Year
2007–2014
Section
Mouldings and protection › Rear bumper centre mount - r r
Body fittingsRear bumper centre mount - r r

REAR BUMPER CENTRE MOUNT - R R

Operation 7055B75 · EXTERIOR PROTECTIONS

Removing

Op. 4450B06 LEFT REAR WHEEL - R.R

Op. 4450B08 RIGHT REAR WHEEL - R.R

Op. 7210E66 R.R. REAR BUMPER

1. Remove the rivets using a drill.

2. Remove the bumper centre support.

REAR BUMPER CENTRE MOUNT - R R

Refitting

- Check that the centre support is not damaged.

- Position the centre support.

- Fit the rivets.

Op. 7210E66 R.R. REAR BUMPER

Op. 4450B08 RIGHT REAR WHEEL - R.R

Op. 4450B06 LEFT REAR WHEEL - R.R

Parts & tools for this job For 2007 Fiat Bravo

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.